Chapter 1 Introduction of Dynaform Software 1.1 A brief introduction of Dynaform 1.2 Design ideas of Dynaform 1.3 Analysis process in sheet metal forming by Dynaform Chapter 2 Setting basis of Dynaform software 2.1 Model establishment 2.1.1 Import the model directly 2.1.2 Build the model 2.2 Meshing 2.2.1 2 lines meshing 2.2.2 3 lines meshing 2.2.3 4 lines meshing 2.2.4 Surface meshing 2.2.5 Model Check/Repair 2.3 Blank generation, setting and layout 2.3.1 Blank generation 2.3.2 Blank setting 2.3.3 Blank layout 2.4 Setting tool parts 2.5 Setting the curves 2.5.1 Define the loading curves 2.5.2 Curve operation 2.6 Stamping direction modification 2.7 Setting analysis 2.8 Computational solution 2.8.1 Analysis 2.8.2 One step solution (MSTEP) 2.9 Post-processing 2.9.1 Introduction to post-processing functions 2.9.2 Make an animation Chapter 3 Nesting and drawing of low box-shaped workpiece with flange , 3.1 Technological analysis of low box-shaped workpiece with flange 3.2 Set up the model 3.3 Database Operations 3.4 Meshing 3.5 Quick setting 3.6 Analysis 3.7 Post-processing Chapter 4 Analysis on the two-stage drawing process of cylindrical parts 4.1 Technological analysis of cylindrical workpiece 4.2 First drawing analysis 4.3 Second drawing analysis Chapter 5 Analysis on V-bending springback process 5.1 V bending springback process analysis 5.2 Set up the model 5.3 Database operations 5.4 Meshing 5.5 Quick setting 5.6 Analysis 5.7 Springback analysis
5.8 Springback result analysis Chapter 6 Analysis on hydraulic drawing process 6.1 Technological analysis of stepped cylindrical workpiece 6.2 Set up the 3D model 6.3 Database operation 6.4 Meshing 6.5 Auto setup 6.6 Analysis 6.7 PostProcess Chapter 7 Analysis on the hydraulic bugling process for tube 7.1 Technological analysis of tube bugling 7.2 Set up the 3D model 7.3 Database operation 7.4 Meshing 7.5 Auto setup 7.6 Analysis 7.7 PostProcess Chapter 8 Analysis on the drawing process of a car hood 8.1 Create a 3D model 8.2 Database operations 8.3 Meshing 8.4 Surface engineering 8.5 Set draw bead type 8.6 Determine the blank shape and size 8.7 Set simulation parameters 8.8 Set analysis parameters and solve 8.9 Post-processing Chapter 9 Analysis on the drawing process of a car left and right protection plates 9.1 Technological analysis of the left and right protection plate 9.2 Create a 3D model 9.3 Database operations 9.4 Meshing 9.5 Surface engineering 9.6 Set simulation parameters 9.7 Set analysis parameters and solve 9.8 Post-processing Appendix Reference
[